Software Update - SlinkE Bootloader v1.2
Link to zip file: SlinkE_Bootloader_Updater v1.2.zip
Released 21 Oct 2016
This is an important update to address a potential safety issue where the SlinkE firmware, under limited circumstances, may become corrupted during startup.
After installing this bootloader update, you will then also need to install the latest SlinkE firmware v1.2 !
Change log
Enhanced protection against inadvertent flash commands during bootup
Instructions for use
- There is no software installation required - just unzip and save the executable file in a convenient location (eg your Desktop, or My Documents folder).
- Connect a Jeti USBa adapter to a free port on your PC
- Double click to start the firmware updater
- When prompted, connect the Ext lead of your SlinkE to the USBa adapter. Sometimes you may need to re-attempt connections a few times before the update program recognises the SlinkE. This is normal.
- The update will begin and take a few seconds to complete. When completed, disconnect the SlinkE and exit the program.
- After updating the bootloader, you will then need to re-install the latest SlinkE firmware.
SlinkE - firmware update 1.2
Link to zip file: SlinkE_Bootloader_Updater v1.2.zip
Released 21 Oct 2016
This firmware update provide no additional functionality, and is only required to maintain compatibility with the updated bootloader v1.2.
Instructions for use
- There is no software installation required - just unzip and save the executable file in a convenient location (eg your Desktop, or My Documents folder).
- Connect a Jeti USBa adapter to a free port on your PC
- Double click to start the firmware updater
- When prompted, connect the Ext lead of your SlinkE to the USBa adapter. Sometimes you may need to re-attempt connections a few times before the update program recognises the SlinkE. This is normal.
- The update will begin and take a few seconds to complete. When completed, disconnect the SlinkE and exit the program.